Creo and Solidworks PDM integration

[AL_10344004]

Any body have worked on integration of Solidworks PDM and Creo? Need help in this case.

[avillanueva]

Almost misread this. Are you asking if anyone has managed Creo data in Solidworks PDM or are your trying to integrate Windchill with Solidworks PDM? 

[AL_10344004]

I am asking for anyone has managed Creo data in Solidworks PDM

[avillanueva]

Unless you've already done so, this request might get better attention in the Creo forum. Most folks here would be managing Creo data in Windchill. That does not mean there is a person here who does both currently or in former role.

[AL_10344004]

Thank you for suggestion, i have also asked same question in Creo forum also. Hope to get good response.

[achirila · Accepted solution]

Hi @AL_10344004,

Thank you for your question!

However, I can see you posted the same on the Creo forum here and other Community users have started to engage. To avoid confusion, I am locking this topic for new comments. I hope you find the right answer soon!

Thank you for using the PTC Community!