cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Showing results for 
Search instead for 
Did you mean: 

Community Tip - You can subscribe to a forum, label or individual post and receive email notifications when someone posts a new topic or reply. Learn more! X

Manufacturing Symbol in Windchill 10.0

jbs5
1-Newbie

Manufacturing Symbol in Windchill 10.0

We have recently moved to Windchill 10.0 from Intralink 3.4. In Intralink, whenever I create a new Manufacturing assembly, it shows as a different symbol but same does not happen in PDMLink and it shows me as an assembly symbol. Please refer figure. (the manufactrung symbol which you can see in the figure are checked out assemblies which has been created and checked in at a time of Intralink.)

Any help is appreciated.

Thanks,

Jay

PlanetPTC.JPG

ACCEPTED SOLUTION

Accepted Solutions
CeliaLee
1-Newbie
(To:jbs5)

Jay,

The issue arose when Creo Manufacturing assemblies removed the *.mfg and on the PDMLink side we did not catch immediately that we needed to identify the Manufacturing assembly sub category. This has been fixed only recently and will be made available in 10.0 M030.

Celia

View solution in original post

2 REPLIES 2
CeliaLee
1-Newbie
(To:jbs5)

Jay,

The issue arose when Creo Manufacturing assemblies removed the *.mfg and on the PDMLink side we did not catch immediately that we needed to identify the Manufacturing assembly sub category. This has been fixed only recently and will be made available in 10.0 M030.

Celia

jbs5
1-Newbie
(To:CeliaLee)

Thanks Celia.

Jay

Announcements


Top Tags