We have recently moved to Windchill 10.0 from Intralink 3.4. In Intralink, whenever I create a new Manufacturing assembly, it shows as a different symbol but same does not happen in PDMLink and it shows me as an assembly symbol. Please refer figure. (the manufactrung symbol which you can see in the figure are checked out assemblies which has been created and checked in at a time of Intralink.)
Any help is appreciated.
Thanks,
Jay
Solved! Go to Solution.
Jay,
The issue arose when Creo Manufacturing assemblies removed the *.mfg and on the PDMLink side we did not catch immediately that we needed to identify the Manufacturing assembly sub category. This has been fixed only recently and will be made available in 10.0 M030.
Celia
Jay,
The issue arose when Creo Manufacturing assemblies removed the *.mfg and on the PDMLink side we did not catch immediately that we needed to identify the Manufacturing assembly sub category. This has been fixed only recently and will be made available in 10.0 M030.
Celia
Thanks Celia.
Jay