cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Showing results for 
Search instead for 
Did you mean: 

Mapping WT Attributes to ProE Parameters

Highlighted
Newbie

Mapping WT Attributes to ProE Parameters

I am attempting to auto-populate my clients drawing border with Change No. information. I am having difficulty in getting the attributes to map to the CAD parameters and subsequently show on the border itself where the CAD params are called up in a table. Please see the attached .ppt file for further information but any help would be greatly appreciated.

Jay

1 REPLY 1

Re: Mapping WT Attributes to ProE Parameters

HI ,

This can be achieved by Customization only, Please refer "Using Pro/ENGINEER® Wildfire™ with Windchill® Windchill 9.1 September 2010" @ page #153.

This will resolve your requirement.