Mini tripod for single extruder

Building on the feedback from James, I modified the parts for 3D printers with a single extruder. 


  • Cap - Has a flat top for building upside down as shown above.
  • Leg - Split in two for gluing together after printing.  Only two halves shown.
  • Centre boss - Has the lower rounds removed. These would need machining or hand finishing after printing.


The unknown is whether the approximation for an Acme thread will build properly without support.

I also changed the leg clamp pattern to allow the legs to be set at different angles to cope with sloping surfaces.

Please leave feedback here if you build a set of parts.