How to move bend note in drawing

[MichalLukac]

Hello, Is it possible to move the atachment point of  bend note in sheetmetal drawing? I can move the text but need to move the attachment point also (to move along bend axis).

I have long part and need to show the view as broken, but I cannot bacause the attachment point of the note is in the middle of the bend axis, therefore if I want to show the bend note i need to show also the center of the view else the note points outside the view.

(in creo 3)

thanks for reply.

michal

This thread is inactive and closed by the PTC Community Management Team. If you would like to provide a reply and re-open this thread, please notify the moderator and reference the thread. You may also use "Start a topic" button to ask a new question. Please be sure to include what version of the PTC product you are using so another community member knowledgeable about your version may be able to assist.

[RaphMORIN]

Hi, You can right click on the attachment line and select change reference. The only problem is that you lose the link between this note and the model as the warning message you'll get says. I think this is the only way to do what you want.

[JLG · Accepted solution]

Find out what the bend note contains:

Create a new note with this same content (in picture, "&BEND_NOTE_1:FID_135").  Erase the original note.

[MichalLukac]

Ok, this seems to be better solution...