Community Tip - Did you get called away in the middle of writing a post? Don't worry you can find your unfinished post later in the Drafts section of your profile page. X
I have an instance level table that I would like to move back to the parent level table. Any suggestions as to how this can be accomplished. I know that I will still need to differentiate between the two models, but can this be done somewhat cleanly.
I would like to put the d74 dimension from the instance level table back into the parent table after the M22 component.
I realize now that I circle the 1047_8015 part vs the 1047_8004 part, but this is true for several of these instances.
Thanks, Dale