cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Showing results for 
Search instead for 
Did you mean: 

Community Tip - If community subscription notifications are filling up your inbox you can set up a daily digest and get all your notifications in a single email. X

Creo 4.0 mistake 0x06000012

Vend
3-Visitor

Creo 4.0 mistake 0x06000012

Hi! 

For a few days ago i have upgraded my Creo Parametric 3.0 up to 4.0. When i try to open it, it says that quality agent could not run and all crashes. I have win 10 and M020 version of Creo if it has something to do with the issue.

1 ACCEPTED SOLUTION

Accepted Solutions
Lemons
1-Newbie
(To:Vend)

Hey,

 

I just had the same issue as you after installing Creo 4.0 for the first time (0x06000012).

 

In my case I deinstalled the quality manager from within the downloaded folder:

(...\MED-100WIN-CD-410_M030_Win64\install\addon):

1. Right click on "qualityagent_64.msi"

2. Select deinstall

 

Afterwards I reinstalled the the quality agent, but I had to change the directory!

1. Again right click on "qualityagent_64.msi"

2. Change directory from "C:\Program Files (x86)\PTC\Quality Agent" to the 64bit folder where the rest of Creo is installed as well.

"C:\Program Files\PTC\Quality Agent"

3. Finish installation of quality manager.

4. Start Creo and it worked.

 

Maybe this helps someone.

 

Best regards

View solution in original post

7 REPLIES 7
Lemons
1-Newbie
(To:Vend)

Hey,

 

I just had the same issue as you after installing Creo 4.0 for the first time (0x06000012).

 

In my case I deinstalled the quality manager from within the downloaded folder:

(...\MED-100WIN-CD-410_M030_Win64\install\addon):

1. Right click on "qualityagent_64.msi"

2. Select deinstall

 

Afterwards I reinstalled the the quality agent, but I had to change the directory!

1. Again right click on "qualityagent_64.msi"

2. Change directory from "C:\Program Files (x86)\PTC\Quality Agent" to the 64bit folder where the rest of Creo is installed as well.

"C:\Program Files\PTC\Quality Agent"

3. Finish installation of quality manager.

4. Start Creo and it worked.

 

Maybe this helps someone.

 

Best regards

vladC1
1-Newbie
(To:Lemons)

worked for me, thank you very much!

Worked also with my 7.0 student version! Thanks!

How did you re install the quality agent?

 


@DA_9902072 wrote:

How did you re install the quality agent?

 


Hi,

please read https://community.ptc.com/t5/PTC-Academic-Program-Discussions/Licensing-Error-Creo-7-0-2-0/m-p/708655 discussion.


Martin Hanák

@Lemons you just saved my 90 mins of uninstalling, downloading, reinstalling. It worked! Thanks a lot🙏🙏🙏

Top Tags