Community Tip - Did you get an answer that solved your problem? Please mark it as an Accepted Solution so others with the same problem can find the answer easily. X
I'm back on to wildfire, I have a segmented part and am trying to show the diameter as a clipped dim but I can seem to get this to happen?
Is there a config setting to allow this? its been a while so can't remember
Hi,
what do you need to get ? Is it something like this ?
I changed dimension to linear and erase one witness line in dimension properties dialog box.
MH
Yes like that but on a radial segment
Hi,
please can you attach picture representing your situation ?
MH