Has anyone got an explaination on the headers in a hole file?
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Notify Moderator
Has anyone got an explaination on the headers in a hole file?
Hi,
This is a general inquiry on what some of the headers mean in a hole file.
I am unable to find any documentation on these headers. I can only find out about call out formats.
The headers I am referring to are:
FASTENER_ID BASIC_DIAM THREAD TAP_DR TAP_DEC PERCENT_THREAD CLEAR_DR_CLOSE CLOSE_DEC CLEAR_DR_FREE FREE_DEC CLEAR_DR_MED MED_DEC CBOREDIAM CBOREDEPTH CSINKDIAM CSINKANGLE BOTCSINKDIAM BOTCSINKANGLE
I know most are self explanatory, however there are some that I am not 100% sure on.
What is the difference between DR and DEC values?
What is THREAD_PERCENT?
I am creating additional hole files and would like to fully understand them first.
Many thanks,
Miles
Solved! Go to Solution.
- Labels:
-
Parametric
- Tags:
- hole file
Accepted Solutions
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Notify Moderator
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Notify Moderator
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Notify Moderator
Thank you so much.
I completely missed that in the help file. How I do not know, I think I need to go home now. 🙂
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Notify Moderator