cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Showing results for 
Search instead for 
Did you mean: 

Community Tip - Help us improve the PTC Community by taking this short Community Survey! X

Cross-Section View with Z-Clip

AndrewFeisthamm
1-Newbie

Cross-Section View with Z-Clip

So here is my problem...I have a view showing a total cross-section and I would like to not show all of the geometry behind the section, only some of it. However, when I try to add a z-clip, the hatch disappears. The strange part is that it still exists, because it highlights when I put my mouse over it and when I select it, but as soon as I unselect it, the hatch goes away. I suppose I could accomplish the same thing by using a combination of component display and edge display, but that gets kind of cumbersome. Any other suggestions???
This thread is inactive and closed by the PTC Community Management Team. If you would like to provide a reply and re-open this thread, please notify the moderator and reference the thread. You may also use "Start a topic" button to ask a new question. Please be sure to include what version of the PTC product you are using so another community member knowledgeable about your version may be able to assist.
3 REPLIES 3

double check that your datum plane for the section is going in the correct direction, usally when i have this problem all i do is flip the plane and that fixes it.

Yeah, I already tried that. The section is pointed to the correct direction and the Z-Clip reference is also on the correct side of the section.

try removing the hatching before applying z-clip. ankur
Top Tags