When a drawing has a very large radius, I need to be able to show the centre point along with the curved radius. When the view appears on the drawing there is a large space between the centre and the radiused curve, which I would like to minimize. Ive seen it done on manual drawings where the radius leader is jogged (zig-zag) to depict the dimension. Can this be done on ProE? This thread is inactive and closed by the PTC Community Management Team. If you would like to provide a reply and re-open this thread, please notify the moderator and reference the thread. You may also use "Start a topic" button to ask a new question. Please be sure to include what version of the PTC product you are using so another community member knowledgeable about your version may be able to assist.
You're not going to want to hear this, before Wildfire, it was possible to move "clip" radius center points as I recall. Here's a work-around I located: https://www.ptc.com/appserver/cs/view/solution.jsp?n=/35675.htm A day without sunshine is like night.