cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Showing results for 
Search instead for 
Did you mean: 

Dimensioning large radii on a drawing

BarryMason
1-Newbie

Dimensioning large radii on a drawing

When a drawing has a very large radius, I need to be able to show the centre point along with the curved radius. When the view appears on the drawing there is a large space between the centre and the radiused curve, which I would like to minimize. Ive seen it done on manual drawings where the radius leader is jogged (zig-zag) to depict the dimension. Can this be done on ProE?
This thread is inactive and closed by the PTC Community Management Team. If you would like to provide a reply and re-open this thread, please notify the moderator and reference the thread. You may also use "Start a topic" button to ask a new question. Please be sure to include what version of the PTC product you are using so another community member knowledgeable about your version may be able to assist.
1 REPLY 1

You're not going to want to hear this, before Wildfire, it was possible to move "clip" radius center points as I recall. Here's a work-around I located: https://www.ptc.com/appserver/cs/view/solution.jsp?n=/35675.htm A day without sunshine is like night.
Announcements