cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Showing results for 
Search instead for 
Did you mean: 

Display subharness only in drawing.

ptc-125863
2-Guest

Display subharness only in drawing.

Associates,

I am a relative newbie to the cabling module and I am hoping to
get some assistance. I have created an assembly and added a harness that
has 3 subharness' that are based on the assembly sequence. I am now
creating a drawing of the assembly and I want to show only specific
suharness' in certain views to demonstrate the order in which they have to
be assembled. However, I have tried Drawing Display and View Manager but
have been unsuccessful in showing a single subharness in a drawing view.
Has anyone done this or know how it could be accomplished? I think I
could do it with family tables but that would be a bit messy. Perhaps I
require a different approach for harness creation? Any assistance that
could be rendered would be greatly appreciated.

Dave
This thread is inactive and closed by the PTC Community Management Team. If you would like to provide a reply and re-open this thread, please notify the moderator and reference the thread. You may also use "Start a topic" button to ask a new question. Please be sure to include what version of the PTC product you are using so another community member knowledgeable about your version may be able to assist.
1 REPLY 1

For such assembly step representations yu can use Process Plan under File>New>Assembly>Process Plan and then you can call the steps into your drawing file. This module is especially for this purpose.

Ali Akguner

Announcements