cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Showing results for 
Search instead for 
Did you mean: 

Drawing notes with dim refs

ptc-2079015
1-Newbie

Drawing notes with dim refs

In WF 2 I remember making notes for counterbored holes that referenced the counterbore's dim value and after the note was complete the dimension would automatically erase itself so that there was no double dimensioning. In WF 4 it isn't doing that by default and leaves the dimension on the drawing. Any idea on the config.pro option that controlls that? C.Moyer
This thread is inactive and closed by the PTC Community Management Team. If you would like to provide a reply and re-open this thread, please notify the moderator and reference the thread. You may also use "Start a topic" button to ask a new question. Please be sure to include what version of the PTC product you are using so another community member knowledgeable about your version may be able to assist.
4 REPLIES 4

What are you talking about? This is not possible.

???

Hi Moyer, I don't have WF4 right now but i'm sure that if it can be done using WF2, surely WF4 also. Are you sure you input the correct dimension id in your notes? are you using the model's dimension id or draft dimension id in your notes?

"Caleb Moyer" wrote:

In WF 2 I remember making notes for counterbored holes that referenced the counterbore's dim value and after the note was complete the dimension would automatically erase itself so that there was no double dimensioning. In WF 4 it isn't doing that by default and leaves the dimension on the drawing. Any idea on the config.pro option that controlls that? C.Moyer

Announcements