cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Showing results for 
Search instead for 
Did you mean: 

GUIDE BUSH IN EMX

asim
1-Newbie

GUIDE BUSH IN EMX

I have defined a new EMX project with Moldbase type set to MFG. I assembled a Guide Bush which is offset from its reference by 10mm as shown in the figure http://www.mcadcentral.com/proe/forum/forum_posts.asp?TID=25397&PN=1
Now the EMX does not create the BORE HEAD DIA and DEPTH in the workpiece according to the head size of the bush for figure click
http://www.mcadcentral.com/proe/forum/forum_posts.asp?TID=25397&PN=1

Thanks in advance.

Asim Rashid

This thread is inactive and closed by the PTC Community Management Team. If you would like to provide a reply and re-open this thread, please notify the moderator and reference the thread. You may also use "Start a topic" button to ask a new question. Please be sure to include what version of the PTC product you are using so another community member knowledgeable about your version may be able to assist.
0 REPLIES 0
Announcements