Local Milling

[ObdulioCorado]

Hi,

Has anybody had any issues with local milling?

I recently used it but half ways thru the sequence I got an error at the controll that the arc center was out of range. I made several changes to the parameters but got the same error.

Any replys will be appreciated.

Thanks,

Obdulio Corado

This thread is inactive and closed by the PTC Community Management Team. If you would like to provide a reply and re-open this thread, please notify the moderator and reference the thread. You may also use "Start a topic" button to ask a new question. Please be sure to include what version of the PTC product you are using so another community member knowledgeable about your version may be able to assist.

[DanielSantos]

Have you tried to revise your post-processor settings for arcs?Maybe you should break them 90º/180º? Are they in any plane other than XY? Arc center is absolute or incremental?

My first bet is that you post need to be enhanced...

JM2C

Regards,

Daniel Santos - Sr. NC Programmer / CAM Support

Liebherr Aerospace Brasil