Pro-Users, I am sure this has been asked before, but I am in a hurry and I don't have time to investigate previous questions. I have a plastic part that has a section that is a diametrical "chord" connector. We have created a curve and I would like to know if there is an easier way to measure to the complete length of the curve. Right now we have to click on each individual segment, write down the length and continue this process...adding all of the segments up. Is there a better way to measure it all at once as opposed to segment by segment? Thanks. For what it is worth, I will post a summary as I get time.
This thread is inactive and closed by the PTC Community Management Team. If you would like to provide a reply and re-open this thread, please notify the moderator and reference the thread. You may also use "Start a topic" button to ask a new question. Please be sure to include what version of the PTC product you are using so another community member knowledgeable about your version may be able to assist.
Pro-Users, Thank you for all of the responses. I might not have given enough information to detail what we were trying to accomplish, but it was much simpler than I thought. We already had a curve and all we had to do was select measure in the analysis menu, then select curve length for type and feature for definition type. Simple as that! We were going into the sketcher and selecting each segment and adding up the length of each of the segments.