cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Showing results for 
Search instead for 
Did you mean: 

Snap Line and Dimension Cleanup default offset values

unknown1
1-Newbie

Snap Line and Dimension Cleanup default offset values

Sorry, I must be having a blackout, but I can't find where to control the
default offset values for:

* Dimension Cleanup

and

* Inserting Snaplines

Searched on my site and in the knowledge base for snap lines and clean
dimension but didn't find any relevant info.

Any ideas?

TIA,

+------------------------------------------------------+
| Olaf Corten - CAD Supervisor - Engineering
| Company: Besi Molding - Duiven - The Netherlands
| Sites: http://www.proesite.com <http: www.proesite.com="/>
| http://www.ptcuser.nl <http: www.ptcuser.nl="/>
+------------------------------------------------------+


This thread is inactive and closed by the PTC Community Management Team. If you would like to provide a reply and re-open this thread, please notify the moderator and reference the thread. You may also use "Start a topic" button to ask a new question. Please be sure to include what version of the PTC product you are using so another community member knowledgeable about your version may be able to assist.
2 REPLIES 2

That would be a good thing to know. I did not know that there was any way of
controlling the default for that.

Michael P. Locascio

If you want to change value of offset or increment for snap line than insert below value to dtl file.

default_clean_dim_increment 8

default_clean_dim_offset 5

Young Kim.

Announcements