cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 

Community Tip - When posting, your subject should be specific and summarize your question. Here are some additional tips on asking a great question. X

Variable Section Sweep that Transitions to a Pin Point

NEALROSENBLUM
1-Newbie
1-Newbie
‎Sep 01, 2009 08:11 PM
‎Sep 01, 2009 08:11 PM

Variable Section Sweep that Transitions to a Pin Point

All,

How would you create a variable section sweep that transitions from some arbitrary shape to a pin point?

TIA.

WF4.0, M070

Sincerely,
Neal Rosenblum
Geometrix Engineering, Inc.
201 N. 13th Avenue
Hollywood, FL 33019
Ph:954-920-2049
Fax: 954-920-9574
Cell:954-649-9399
<u>neal@geometrixeng.c</u>


This thread is inactive and closed by the PTC Community Management Team. If you would like to provide a reply and re-open this thread, please notify the moderator and reference the thread. You may also use "Start a topic" button to ask a new question. Please be sure to include what version of the PTC product you are using so another community member knowledgeable about your version may be able to assist.
Labels:
0 Kudos
Notify Moderator
1 REPLY 1
Greg_McMurray
6-Contributor
6-Contributor
(To:NEALROSENBLUM)
‎Sep 02, 2009 10:27 AM
‎Sep 02, 2009 10:27 AM

It can be done. One way to do it is with 3 trajectories leading to a single point. Sketch a conic only attached to Chain 1 and Chain 2. This particular example I'm thinking of has these chains straddling the Origin on opposite sides. The resulting sweep will terminate at the point of convergence.
0 Kudos
Notify Moderator
Top Tags