Having some trouble with a harness, where when I open the harness in mfg
mode, I can't see the network. I can see locations, but no segements.
Like the network layer is off. But I don't see where I can turn on the
network layer in mfg mode.
Fairly recently switched to wildfire 4, build 50.
This thread is inactive and closed by the PTC Community Management Team. If you would like to provide a reply and re-open this thread, please notify the moderator and reference the thread. You may also use "Start a topic" button to ask a new question. Please be sure to include what version of the PTC product you are using so another community member knowledgeable about your version may be able to assist.