Hello,
I am trying to get a mechanism simulation going. In the mechanism, a lump
slides along another piece and when the lump hits a cam-shaped component,
the camrotates about its pivot until the follower drops off the other end.
The attached pictures may help to make more sense.
Trouble is, I can't get the cam connection to work. The follower just goes
straight through the cam when I drag the lump along its slider.
Any ideas?
Regards, <<cam follower.jpg=">> <<cam follower=" 2.jpg=">>
This thread is inactive and closed by the PTC Community Management Team. If you would like to provide a reply and re-open this thread, please notify the moderator and reference the thread. You may also use "Start a topic" button to ask a new question. Please be sure to include what version of the PTC product you are using so another community member knowledgeable about your version may be able to assist.
