Hi everyone,
I did get a lot of responses this time so thank you all. I apologize if
my question was not very clear... I was struggling with the terminology.
To sum it up, I don't think what I'm looking for is possible.
Someone suggested that the handle (or insertion point or crosshair or
anchor point... I'm still struggling with the terminology) falls in the
geometric center of the sketch; I believe that is exactly what it does.
It works fine for symmetric sketches.
Someone also suggested that a coordinate system in my sketch would be
used at the handle; that did not work for me.
I knew that already, but FYI, it is possible to move the handle in the
sketch by pressing and holding the right mouse button. It will snap to
sketcher entities.
Have a nice day and thanks for your help,
Fred
