Is there a way to enter angles in degrees,minutes, seconds format for a
sketched line?
I know we can do the conversion and input it as a decimal part of a
degree, but I want Wildfire to do the math!
Do I need to set ang_units to ang_min in config.pro?
Ben Loosli
Sr IS Technologist
Engineering Automation Systems
L-3 Communications/Integrated Systems
Waco, TX 76715
254-867-4069
-
This thread is inactive and closed by the PTC Community Management Team. If you would like to provide a reply and re-open this thread, please notify the moderator and reference the thread. You may also use "Start a topic" button to ask a new question. Please be sure to include what version of the PTC product you are using so another community member knowledgeable about your version may be able to assist.
sketched line?
I know we can do the conversion and input it as a decimal part of a
degree, but I want Wildfire to do the math!
Do I need to set ang_units to ang_min in config.pro?
Ben Loosli
Sr IS Technologist
Engineering Automation Systems
L-3 Communications/Integrated Systems
Waco, TX 76715
254-867-4069
-
This thread is inactive and closed by the PTC Community Management Team. If you would like to provide a reply and re-open this thread, please notify the moderator and reference the thread. You may also use "Start a topic" button to ask a new question. Please be sure to include what version of the PTC product you are using so another community member knowledgeable about your version may be able to assist.
