cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Showing results for 
Search instead for 
Did you mean: 

Community Tip - Did you get called away in the middle of writing a post? Don't worry you can find your unfinished post later in the Drafts section of your profile page. X

Angular displacements

ben_loosli
1-Newbie

Angular displacements

Is there a way to enter angles in degrees,minutes, seconds format for a
sketched line?
I know we can do the conversion and input it as a decimal part of a
degree, but I want Wildfire to do the math! Smiley Happy
Do I need to set ang_units to ang_min in config.pro?



Ben Loosli
Sr IS Technologist
Engineering Automation Systems
L-3 Communications/Integrated Systems
Waco, TX 76715

254-867-4069
-



This thread is inactive and closed by the PTC Community Management Team. If you would like to provide a reply and re-open this thread, please notify the moderator and reference the thread. You may also use "Start a topic" button to ask a new question. Please be sure to include what version of the PTC product you are using so another community member knowledgeable about your version may be able to assist.
1 REPLY 1
mjenkins
5-Regular Member
(To:ben_loosli)

Just click on the properties of the angle dimension and change Angular Dimension Units as shown...

Michael R. Jenkins P.E.
Design Engineer
Direct: 816-801-2332
Fax: 816-891-9432

Commercial Vehicle Systems
Haldex Brake Products Corporation
10930 North Pomona Avenue
Kansas City, MO 64153-1215
Top Tags