Process manager question.

[snguyen]

In process manager is there an option when selecting holes by diameter for a
hole making sequence?

I have not used the process manager since WF2. Back then you could only do a
couple of nc sequences so I gave up on it. Since I am now on WF4 I was
playing with it the other day and notice that there a lot of improvements
from the original one in WF2. I am wondering is anybody out there in ProNC
land using the process manager over the Menu Manager? What are the benefits?


Son Nguyen
Tooling Designer & Programmer
785-667-7763

108 W. 2nd Street
Assaria, Kansas 67416

This thread is inactive and closed by the PTC Community Management Team. If you would like to provide a reply and re-open this thread, please notify the moderator and reference the thread. You may also use "Start a topic" button to ask a new question. Please be sure to include what version of the PTC product you are using so another community member knowledgeable about your version may be able to assist.

[BarryS]

I only use Process Manager for Importing templates copied from other similar
parts.
I rather use mapped keys for all of my NC sequences.
That's my 2 cents.
Barry

On Wed, Feb 11, 2009 at 6:07 AM, Son Nguyen
<->wrote:

> In process manager is there an option when selecting holes by diameter for
> a
> hole making sequence?
>
> I have not used the process manager since WF2. Back then you could only do
> a
> couple of nc sequences so I gave up on it. Since I am now on WF4 I was
> playing with it the other day and notice that there a lot of improvements
> from the original one in WF2. I am wondering is anybody out there in ProNC
> land using the process manager over the Menu Manager? What are the
> benefits?
>
>
> Son Nguyen
> Tooling Designer & Programmer
> 785-667-7763
>
> 108 W. 2nd Street
> Assaria, Kansas 67416
>