cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Showing results for 
Search instead for 
Did you mean: 

Assembly is saving component files, and it should not be based on past behavior (pre WF3)

Highlighted
Newbie

Assembly is saving component files, and it should not be based on past behavior (pre WF3)

WF3 M170
Windchill 8.0 M040

I just created new workspace, then created a few new parts only saved to workspace, not uploaded or checked in. Now I create an assembly and assembly the first component just happens to be a family part. I'm pretty sure that I verify all my parts before saving and closing. I've included my start part files for parts and assemblies, as well as a copy of my config file. As mentioned in subject this was never a behavior prior to WF3. I do run an saved analysis feature and the end of part files and assembly files to grab volume and weight. Just random thought that the one in the assembly might be causing me this problem. Not sure though. Please help me out. Thanks.


Eric Fleming
Engineering Technician
ITT Corporation
Residential & Commercial Water
1 Goulds Dr.
Auburn, NY 13021
Phone: 315-258-4840
Fax: 315-258-4809
-<">mailto:->