Community Tip - Did you know you can set a signature that will be added to all your posts? Set it here! X

Translate the entire conversation x

Intralink 3X beyond WF4

homerosaldana
5-Regular Member

Intralink 3X beyond WF4

I finally found some free time and got around to launching WF5 and CREO 1.0 in a linked session of Intralink 3.4 M062. I understand that WF5 and beyond is not supported which basically means use at your own risk. Surprisingly I was able to create parts and assemblies in both WF5 and Creo 1.0 and check them into Intralink commonspace. Has anyone else attempted this? If so, to what level of success?

-H Saldana
AES
512-279-0822
0 REPLIES 0
Announcements



Top Tags