Community Tip - Did you get called away in the middle of writing a post? Don't worry you can find your unfinished post later in the Drafts section of your profile page. X

Translate the entire conversation x

Add the ability to locate Family Table Solid.prt cutters and create cutting data in an instance of a

metalman
6-Contributor

Add the ability to locate Family Table Solid.prt cutters and create cutting data in an instance of a

Currently ProManf will not “find” a tool if it lives inside a family table. For example, it is nice to be able to create one Generic drill and then family table the lengths and diameters, which works fine in Creo, but ProManf will not recognize a tool that is an instance in a family table. Also, it is not possible to set cutting information parameters in the family table. Both of the features would make Tool management much more useful.

0 REPLIES 0
Announcements
NEW Creo+ Topics: Real-time Collaboration

Top Tags