I am looking for any pointers or tutorials out there for animation. Just
basic stuff. I have a 8-10 piece assembly I would like to make short
assembly method animations of. I have been poking around a little. I did
figure out how to make key frames but I could not figure out how to make it
animate between the positions I had set.
Thanks in advance.
--
Ron Rich
Staff Mechanical Engineer
Keithley Instruments
28775 Aurora Rd.
Solon, OH 44139
PH. 440-498-2842
This thread is inactive and closed by the PTC Community Management Team. If you would like to provide a reply and re-open this thread, please notify the moderator and reference the thread. You may also use "Start a topic" button to ask a new question. Please be sure to include what version of the PTC product you are using so another community member knowledgeable about your version may be able to assist.
