Hello,
I am trying to model a chess piece for a project. I have completed all of the components that I want my piece to have, except for a brick pattern cut in around the outside of the center cylinder. I have searched quite a bit on the internet for topics covering this, but all I have found is Solidworks advice. I am using Creo Parametric 3.0.
Any help would be greatly appreciated!
This thread is inactive and closed by the PTC Community Management Team. If you would like to provide a reply and re-open this thread, please notify the moderator and reference the thread. You may also use "Start a topic" button to ask a new question. Please be sure to include what version of the PTC product you are using so another community member knowledgeable about your version may be able to assist.
