cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Showing results for 
Search instead for 
Did you mean: 

Community Tip - Did you get called away in the middle of writing a post? Don't worry you can find your unfinished post later in the Drafts section of your profile page. X

Creo 3 Drawing notes - how to switch dual below/right?

proed
1-Newbie

Creo 3 Drawing notes - how to switch dual below/right?

Hi there, we must be missing something - it appears Creo 3 doesn't allow editing for dual dimension properties - eg: show them below or right?

In Creo 2, you can select the dimension, then right-click - Properties and adjust there - but Creo 3 has no option for this?

Nothing shows in PTC help search.

Thanks for any guidance.

Regards

Edwin

dual_below.PNG


This thread is inactive and closed by the PTC Community Management Team. If you would like to provide a reply and re-open this thread, please notify the moderator and reference the thread. You may also use "Start a topic" button to ask a new question. Please be sure to include what version of the PTC product you are using so another community member knowledgeable about your version may be able to assist.
2 REPLIES 2
proed
1-Newbie
(To:proed)

Hey folks, I have a workaround for now, though hoping there's a "proper" way to do this...

Remove the dimension from the note, then right-click Properties on it, set below, then add to note again...

Edwin

dual_below2.PNG

proed
1-Newbie
(To:proed)

I guess no-one has an answer on this?

It's come up a few times with various colleagues now...

Top Tags