cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Showing results for 
Search instead for 
Did you mean: 

Creo Simulate moving reference frame

ccantarelli
8-Gravel

Creo Simulate moving reference frame

Good morning,

 

I have a question about moving reference frame.

I have created a coordinate system on a face of the component that I am simulating - static simulation - with z axis normal to the surface and all the references selected with respect to the face geometrical features.

Then I have imposed a displacement along the z direction of this coordinate system, because I want it to be normal to the surface. The question is: if the face face moves (suppose for example that it will rotate), will this reference frame always move with it (such that the z direction will always remain normal to the face) or will it remain fixed as I had defined it during the set up of the simulation?

No large displacement option has been selected.

Thank you very much for the support.

 

Bets regards 

1 REPLY 1

No; a moving reference frame is nonlinear. I don't think Creo has the capability to do followers expect for pressure loads.

Announcements