Decimal places in Bend Notes
‎Apr 13, 2014
05:53 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Notify Moderator
‎Apr 13, 2014
05:53 AM
Decimal places in Bend Notes
All
Is it possible to control the number of decimal places used in a bend note on a drawing for the flat state of a sheet metal part?
Regards,
Neal
This thread is inactive and closed by the PTC Community Management Team. If you would like to provide a reply and re-open this thread, please notify the moderator and reference the thread. You may also use "Start a topic" button to ask a new question. Please be sure to include what version of the PTC product you are using so another community member knowledgeable about your version may be able to assist.
Labels:
- Labels:
-
General
0 REPLIES 0