Drawing Angle Dimension Not Clocked on Centerline

[nallen-2]

Hello,

Attached should be a screenshot of the issue I'm having getting a dimension to behave. I have selected to display the angle between features of a pattern, but it doesn't line up directly on the centerline of the hole. Any suggestions?

This thread is inactive and closed by the PTC Community Management Team. If you would like to provide a reply and re-open this thread, please notify the moderator and reference the thread. You may also use "Start a topic" button to ask a new question. Please be sure to include what version of the PTC product you are using so another community member knowledgeable about your version may be able to assist.

[StephenW · Accepted solution]

I think you need to regenerate.  Green dimensions (in my color scheme) mean a dimension has been changed but the model hasn't been regenerated.

Once regenerated, you may need to update the sheet (depending on your config settings).

[nallen-2]

Green shows up when I hover over dimensions, on my system Red is for that situation. Thank you anyway Steven, I found a solution.

I redefined the pattern to be patterned on a dimension rather than the axis and now the 60 degree dimension shows up shows up on the centerline.

Best, Nicholas