Hello could someone please help me to understand how can i run a simulation with fasteners? for an exemple on the model below i have a part and a support both connected by fasteners and with a pre load how should i simulate the fasteners in this case?
Thak you very much,
Eduardo.
This thread is inactive and closed by the PTC Community Management Team. If you would like to provide a reply and re-open this thread, please notify the moderator and reference the thread. You may also use "Start a topic" button to ask a new question. Please be sure to include what version of the PTC product you are using so another community member knowledgeable about your version may be able to assist.
