Community Tip - Did you get called away in the middle of writing a post? Don't worry you can find your unfinished post later in the Drafts section of your profile page. X
Is there the oppetunity to tolerate assemblies or only parts?
Hi Josephine,
Can you please elaborate on your question? It is not clear what advice you are looking for.
Thanks,
Amit
Hey Amit,
I became a answer from the German support.
My question was, if I can work with assamblies in the GD&T Advisor or only with parts.
The German support send me a link, there stand that's the tool is only for parts.
Greetings Josy