cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Showing results for 
Search instead for 
Did you mean: 

Community Tip - Did you get called away in the middle of writing a post? Don't worry you can find your unfinished post later in the Drafts section of your profile page. X

Hide some geometry entities in Drawing mode?

David_M
5-Regular Member

Hide some geometry entities in Drawing mode?

Thi has to be the least intuitve thing in Pro/E. Could someone please explain how to hide, say, one edge of an isometric cube in a drawing?

Thanks


This thread is inactive and closed by the PTC Community Management Team. If you would like to provide a reply and re-open this thread, please notify the moderator and reference the thread. You may also use "Start a topic" button to ask a new question. Please be sure to include what version of the PTC product you are using so another community member knowledgeable about your version may be able to assist.
1 ACCEPTED SOLUTION

Accepted Solutions

erase.JPG

Hi

There is an option to control edge display

Edge display> Erase Line> Select line

I hope this will help you

Regards

K.Mahanta

View solution in original post

3 REPLIES 3

erase.JPG

Hi

There is an option to control edge display

Edge display> Erase Line> Select line

I hope this will help you

Regards

K.Mahanta

Can anyone point me to where to find this command in Creo 2.1? Thanks!

StephenW
23-Emerald II
(To:krichardson)

In the layout tab, select edge display, then the menus are the same as above.

Top Tags