How to display bend line in sheetmetal model?

[yseo]

I made planar feature in sheetmetal part.

And added flange wall on edge.

After applied flat pattern I would like to display bend line.

If impossible I would like to display original egde in flatten state.

Is it possible?

This thread is inactive and closed by the PTC Community Management Team. If you would like to provide a reply and re-open this thread, please notify the moderator and reference the thread. You may also use "Start a topic" button to ask a new question. Please be sure to include what version of the PTC product you are using so another community member knowledgeable about your version may be able to assist.

[mbonka · Accepted solution]

Hello Yong Bok Seo

if your flat pattern was created succesfully, then should be created "bend axis" (in my opinion the same like bend lines). See attached picture.

In praxis l´m using this bend axis to sketch lines for engraving ---> it makes work easier for guys from workshop.

Hope it helps...

Regards

Milan Bonka

[yseo]

Hello Milan Bonka

I am really happy to get your good solution.

Thanks a lot

Regards