Community Tip - Did you get called away in the middle of writing a post? Don't worry you can find your unfinished post later in the Drafts section of your profile page.
X
I have the CREO3 version installed. All works well but only in inches. Through "file-options-configurator editor" I was able to change to mm but When I restart or start modelling it stays in inches. Can anybody help? Please
I have the CREO3 version installed. All works well but only in inches. Through "file-options-configurator editor" I was able to change to mm but When I restart or start modelling it stays in inches. Can anybody help? Please
I have the CREO3 version installed. All works well but only in inches. Through "file-options-configurator editor" I was able to change to mm but When I restart or start modelling it stays in inches. Can anybody help? Please
This thread is inactive and closed by the PTC Community Management Team. If you would like to provide a reply and re-open this thread, please notify the moderator and reference the thread. You may also use "Start a topic" button to ask a new question. Please be sure to include what version of the PTC product you are using so another community member knowledgeable about your version may be able to assist.
