cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Showing results for 
Search instead for 
Did you mean: 

Community Tip - If community subscription notifications are filling up your inbox you can set up a daily digest and get all your notifications in a single email. X

Issue on assembly

rlecoeur
2-Explorer

Issue on assembly

Hello,

I have a big problem on creo. Since this morning, it is impossible to modify my assembly. The crash software has every manipulation and I still have the same error message. (see picture)

See attached the log file.

Creo 3.0 M090

CREO FATAL ERROR.JPG

Can you help me please ?

Thank you.

3 REPLIES 3
StephenW
23-Emerald II
(To:rlecoeur)

I would suggest submitting a  support ticket to PTC for traceback errors.

Other suggestions is to try opening the parts and sub assemblies to see if you can find something corrupted. If you are using Windchill, try adding the assembly to a new workspace, sometimes workspaces corrupt.

SandeepKadam07
14-Alexandrite
(To:StephenW)

Hi,

Check error message if you find in message area. Many times we ignore messages shown there.

If you don't find any error message, better to log a case into PTC suuport log. Only PTC team can investigate these traceback files.

Regards

Sandeep

habdul
10-Marble
(To:rlecoeur)

Try upgrading to the latest build. The number of crashes went down when we upgraded from M060 to M110.

Announcements
NEW Creo+ Topics: Real-time Collaboration


Top Tags