Good afternoon!
I'm currently in the midst of a project whereby measurements from a CREO CAD assembly will drive data in a MathCAD document.
It should be possible to mark variables as either read or write for the inbuilt MathCAD analysis tool within CREO.
I remember being told at one point that the variables need to be marked or labled using a string.
I think it was along the lines of 'creo2mc'
Does anyone have any information around this issue?
Regards,
Alex
This thread is inactive and closed by the PTC Community Management Team. If you would like to provide a reply and re-open this thread, please notify the moderator and reference the thread. You may also use "Start a topic" button to ask a new question. Please be sure to include what version of the PTC product you are using so another community member knowledgeable about your version may be able to assist.
