We have a situation where on the same level as the cable, one must add
special screws to replace existing connector screws. the problem is that
when flattening one must add a coordinate system to the screws in order to
allow them to be on the final flattened part. Is there any other way?
regards,
Alfonso
This thread is inactive and closed by the PTC Community Management Team. If you would like to provide a reply and re-open this thread, please notify the moderator and reference the thread. You may also use "Start a topic" button to ask a new question. Please be sure to include what version of the PTC product you are using so another community member knowledgeable about your version may be able to assist.
