cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Showing results for 
Search instead for 
Did you mean: 

Preset View settings

rreiff
1-Newbie

Preset View settings


How do you determine the coordinate systems in 3d for preset view settings?

Where would you get this data within CREO?

AKA, Isometric preset views... I would like to know where I would get that information. Can someone assist?


This thread is inactive and closed by the PTC Community Management Team. If you would like to provide a reply and re-open this thread, please notify the moderator and reference the thread. You may also use "Start a topic" button to ask a new question. Please be sure to include what version of the PTC product you are using so another community member knowledgeable about your version may be able to assist.
2 REPLIES 2
StephenW
23-Emerald I
(To:rreiff)

The default start part and assembly from PTC do not come with any preset views. If you have a company standard start part/assy, you may have some preset view orientations defined.

The "textbook" isometric view would be accomplished by FIRST rotating V by 45 deg and then H by 35.264 deg. Save that as new view and you are all set.

I stole this from someone else and haven't done the actual math on it in years, but it looked right from what I remember. As always, you might want to verify this if you need or want an exact isometric view.

StephenW
23-Emerald I
(To:rreiff)

Here's a better link from the community.

Announcements