Hello
Is it possible to change the bends # of a pipe line when one has two lines in the same assembly, so that the first # of the second line is following the last one of the first line?
Example :
first pipe line: 5 points (2 ends, 3 bends): point # 1,2,3,4,5
secondpipe line:6 points (2 ends,4 bends): point # 1,2,3,4,5,6 --> new point # : 6,7,8,9,10,11
Many thanks advanced.
This thread is inactive and closed by the PTC Community Management Team. If you would like to provide a reply and re-open this thread, please notify the moderator and reference the thread. You may also use "Start a topic" button to ask a new question. Please be sure to include what version of the PTC product you are using so another community member knowledgeable about your version may be able to assist.
