We use Pro/Weld here, and we're having an issue with weld lengths
disappearing. After making some changes to the model, most of the the
weld lengths on the drawing will disappear, but not all will. We've had
this happen in the past, and we've usually been able to track it down to
something in a weld callout somewhere that shouldn't be there, but in
this case, it works one minute, and doesn't the next, and we can't
figure out what is making them disappear.
Interestingly, we've noticed that if we move the view, all of the welds
will show their lengths. However, when we save and get back into the
drawing, all of the lengths will be gone.
Has anyone else seen this, and if so, is there a solution...
WF 2.0 M220
--
This thread is inactive and closed by the PTC Community Management Team. If you would like to provide a reply and re-open this thread, please notify the moderator and reference the thread. You may also use "Start a topic" button to ask a new question. Please be sure to include what version of the PTC product you are using so another community member knowledgeable about your version may be able to assist.
