cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 

Community Tip - Stay updated on what is happening on the PTC Community by subscribing to PTC Community Announcements. X

Red and White Diamond Shape

jmoran
4-Participant
4-Participant
‎Dec 22, 2017 01:05 PM
‎Dec 22, 2017 01:05 PM

Red and White Diamond Shape

Does anyone know what this red and white diamond shape is and how to get rid of it?  I just recently installed M150, Creo 3.0 and it has been there since.  It wasn't there before the install.  It is on my drawing view and model view and is just in the way.  Any help is greatly appreciated.

Red Diamond.JPG

Labels:
0 Kudos
Notify Moderator
4 REPLIES 4
TomU
23-Emerald IV
23-Emerald IV
(To:jmoran)
‎Dec 22, 2017 01:44 PM
‎Dec 22, 2017 01:44 PM

Are you using a space pilot?

0 Kudos
Notify Moderator
jmoran
4-Participant
4-Participant
(To:TomU)
‎Dec 22, 2017 02:21 PM
‎Dec 22, 2017 02:21 PM

Yes.

0 Kudos
Notify Moderator
TomU
23-Emerald IV
23-Emerald IV
(To:jmoran)
‎Dec 22, 2017 03:55 PM
‎Dec 22, 2017 03:55 PM

That symbol appears while you are spinning the model.  Normally it goes away when you stop but with a space pilot it says visible all the time.  This was discussed previously here on the community but I can't find the topic at the moment.  I believe if you unplug the space pilot it will go away.

0 Kudos
Notify Moderator
Mahesh_Sharma
22-Sapphire I
22-Sapphire I
(To:jmoran)
‎Dec 25, 2017 09:34 AM
‎Dec 25, 2017 09:34 AM

This was a known issue and has been corrected in Creo Parametric 3.0 M160 and Creo Parametric 4.0 M040

 

Article 268780

Notify Moderator
Announcements
NEW Creo+ Topics: Real-time Collaboration


Contact Community Management
Top Tags