Round stopping at a datum point

[ptc-141274]

I am trying to create a round on a edge of a rail, that would transition
to stop at a datum point part of the way down that rail. This would
represent geometry where the round cutting tool stops.



I have the datum point in, and I push the transitions button, while in
the round command, but it is not allowing me to pick the datum point?

I am going about this the correct way? Am I missing something?



WF4, M070



Best Regards,



Doug Pogatetz
Mechanical Design Engineer



Northrop Grumman Corporation
224-625-4823
-





This thread is inactive and closed by the PTC Community Management Team. If you would like to provide a reply and re-open this thread, please notify the moderator and reference the thread. You may also use "Start a topic" button to ask a new question. Please be sure to include what version of the PTC product you are using so another community member knowledgeable about your version may be able to assist.

[Spidernate]

Are you hitting all these steps in your workflow?

1.select edge for round

2. click transitions button

3. select which part of the round you want to apply the transition to

4. change the transition type to "stop at reference"

5. pick your point or create it on the fly