cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Showing results for 
Search instead for 
Did you mean: 

TRIM_TOOLPATH_ON_HOLDER

jharper
5-Regular Member

TRIM_TOOLPATH_ON_HOLDER

I have a Re-Roughing sequence (of a .750 ball nose Re-Rough) with a .375 ball nose. The parameters of the tool are properly defined, including the holder parameters. I also have the parameter "Trim_toolpath_on_holder" set to "yes" and "Holder_Clearance" set to ".035". With all known parameters properly defined, the holder still gouges into the reference part.

Am i missing a parameter? Or is this a problem i should submit to PTC?


This thread is inactive and closed by the PTC Community Management Team. If you would like to provide a reply and re-open this thread, please notify the moderator and reference the thread. You may also use "Start a topic" button to ask a new question. Please be sure to include what version of the PTC product you are using so another community member knowledgeable about your version may be able to assist.
0 REPLIES 0
Announcements