Some users are looking for the TT font to be mono-spaced.
Some users are looking for the zero character have a slash in it (an option per the spec). Some feel this might look too busy on a drawing. Perhaps the notes could have this, but not the dimensions? While drawing lettering is specified to be all capitals except as required, some users want the Upper Case "I" [I] different from the Lower Case "l" [l] (for those rare cases), but serifs are getting the objection.
Any additional thoughts/comments on the above?
I will post a summary after a decision is made.
This thread is inactive and closed by the PTC Community Management Team. If you would like to provide a reply and re-open this thread, please notify the moderator and reference the thread. You may also use "Start a topic" button to ask a new question. Please be sure to include what version of the PTC product you are using so another community member knowledgeable about your version may be able to assist.
This message contains information that may be confidential and privileged. Unless you are the addressee (or authorized to receive mail for the addressee), you should not use, copy or disclose to anyone this message or any information contained in this message. If you have received this message in error, please so advise the sender by reply e-mail and delete this message. Thank you for your cooperation.
I know it's not a TT font, but FWIW, I posted a variation of the PTC standard font called "Font" with the modifications Lance describes to the PTC user portal section some months ago (and also a strikethrough version). Ironically, I hated that aspect of the sans serif font on pro/e drawings, but everywhere else, I despise serifed fonts (you may note that this note email is not written in one).